Minisport
|
Minisport |
 
|
AJM164 Pair of rear hard weraing rubber mudflaps with the word mini embossed on them, should fit all models. Price:
Price:
CCC115- BOOT BOARD BRACKET SET This kit contains all the brackets and mounts that were fitted on original Coopers. Price:
14A9838 As fitted to the original cooper ‘S’, this boot lid liner looks great and will tidy up the boot of any Mini! This is a kit that comes with, Boot lid liner, Screws and cup washers (counter sunk) Price:
Consumables- Bood lid liner screw (and collar) This is a boot board/door trim screw and cup collar washer to fit your mini, Sold single as a screw and collar Price:
47H9615 Includes 4 segments to fit between stiffener supports under bonnet, sound insulation keeps engine noise from entering driving compartment. suits all roundnose models- NOT clubman Price:
47H9616- Bonnet insulation kit 3pce (Leyland/square nose type) This is an under bonnet insulation kit to suit the leyland clubman type mini's. This is a universal kit for ALL square nose cars. Price:
MT632 A roll of plastic chrome roof edging, Fits better to earlier cars Pre 1979 that never had the trim fitted as standard. length fits saloon only This is a roll long enough to fit the roof of mini saloons and should not be confused with the later pre-shaped 2 piece sections as fitted by Rover from 1979 on. Price:
DBE1006S- Mini roof gutter chrome strip joining/finishing clip This is a joining clip for the roof gutter silver strip. Price:
CZH3508MS Seat base to suit either Morris/Leyland front seats, this is a must on a lot of minis due to the rubber going hard and breaking, thus putting your bottom lower in the front seat. Price:
Sump Guard...MINI This is a brand new sump guard to fit a mini, as it is in polished alloy it looks GREAT, it has a protective coating on it that you will have to peel off for transport reasons. Price:
C-AJJ3321- SUMPGUARD SQUARE FRONTED ALLOY SUMPGUARD-MONTE CARLO Square front sumpgurd adequate for road use and is cheaper and lighter than c-AJJ3320 RAC/Scottish type made in alloy with fabricated side brackets for strength. Weighs 4.885 kilos also known as Monte Carlo sumpguard Price:
MINI EARLY TYPE STEERING COLUMN SHROUD As fitted to the pre 69 cars such as 850/cooper/deluxe Mk1s Price:
BHM7085- STEERING COWL FROM 76 ROVER/MOKE The plastic 2 piece casing for the steering wheel cowl was introduced in 1976 on the rover model which was for the introduction of twin indicator stalks and a different steering lock.Twin point injection cars have different cowling and swithes. also fits mokes Price:
Mini 2 screw tail light lens, Left hand side This is a left hand tail light lens that has two screw holes in it, this tail light was fitted from about 1967 to 70, this tail light will only fit 2 screw tail lights. Price:
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
