Current Category
Body parts and accessories > Body Accessories

	Mini roof aerial MSA1119- ROOF AERIAL SB300 Minis always looked better and safer from vandalism with a roof Ariel.		Price:	QTY:

	Mini pair of leather black bonnet straps *PAIR* MS121- BONNET STRAPS BLACK *PAIR* Leather Bonnet Straps Available again! Black leather bonnet straps, sold in pairs and at a very cost effective price. These straps are great and can be used for everything from the bonnet to the tool box!		Price:	QTY:

	Mini works type 'black' bonnet strap- sold single C-AJJ3380 BONNET STRAP 'BLACK' ORIGINAL WORKS TYPE (SOLD SEPERATLY) This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. BLACK leather 3.3mm thick from the tanneries for use on horse bridles, with alloy fastening. Screws included. These are sold as one, so If you need a pair you will have to buy two		Price:	QTY:

	Mini works type tan bonnet strap (Sold as one) C-AJJ3381 BONNET STRAP TAN ORIGINAL WORKS TYPE (SOLD SEPERATLY) This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. Original light colour Tan leather 3.3mm thick from the tanneries for use on horse bridles, with alloy fastening. Screws included. These are sold as one, so If you need a pair you will have to buy two		Price:	QTY:

	Mini bonnet hook kit, come with fitting kit*Pair* MS118- BONNET HOOKS (LARGE) RUBBER If you want to hold it in place then this is easy and simple. 4" long rubber hooks can be used on bonnet and/or boot lid. Packaged in pairs with both brackets.		Price:	QTY:

	Chrome boot hinges, PAIR 8B12601 Chrome boot hinges to suit your mini, stand out from the crowd!		Price:	QTY:

	Mini non chrome boot hinges (paint them), PAIR 8B12602- BOOTLID HINGES BARE METAL - (PAIR) A set of boot hinges which does fit and is of decent quality and these are from the same castings as the chromed type but bare for paint application.		Price:	QTY:

	Bootlid gasket set/kit BOOT LID GASKET SET.  This is the full gasket set you will need when you put your bootlid back on your car, the gaskets stop any scratches from occurring and also stops the rust that will occur without the fitment of these.		Price:	QTY:

	Bootlid wires/cables (pair) 14A6740- Boot lid wires, pair   Pair of mini boot lid wires, as fitted to all models, these have a counter sunk end so that screws will fit in very tidy. Always buy pairs so that one is not longer than the other.		Price:	QTY:

	Mini boot handle comes with key, all Australian models New Boot Handle Mini boot handle, this is the same on all Morris & Leyland Minis, this also has the longer shaft so it can be also used on Mini van rear doors., comes as shown with new keys.		Price:	QTY:

	Mini boot latch cover- stainless steel SMB08- Mini boot latch cover- stainless steel This will really clean up your boot lid.		Price:	QTY:

	Mini battery bolt, (loop end) 6cm long 5L1158- BATTERY BOLT REAR WITH LOOP END 6cm long (2.5") This is the looped battery fixing rod for all aussie cars, This rod fits on the back bracket by the positive earth terminal with a nut and bolt.		Price:	QTY:

	Mini battery bolt, (hook end) 5.5cm long 5L1159- BATTERY BOLT FRONT WITH A HOOK END 5.5cm long (2.25") This is the open loop rod by the negative terminal which hooks into the battery box bracket (HAM2457)		Price:	QTY:

	Mini battery bar, helps hold battery down HAM2457- BATTERY BAR Currently the only battery bar available from rover to fit all saloons. This is the strap that clamps down on the battery.		Price:	QTY:

	Battery box cover An original type battery box cover, imported directly from UK, not the junk ones that tend to be available on the market.		Price:	QTY:

Previous Page 1 2 3 [4] 5 6 7 8 9 Next Page