Minisport
|
Minisport |
 
|
Cooling The mini cooling system was never really designed for Australian hot conditions, that is why you should never take shortcuts in keeping your mini cool, always take your time, inspect all areas like water pump condition/radiator core condition/fan/thermostat condition. Call Sales/enquiries on: 08-8177-1275 or email us 825 Belt to drive your waterpump/fan and alternator, if running a generator please see 815 belt. Price:
FAN BELT POLY V BELT WHEN AIR CON FITTED FROM rover For those lucky people who have factory fitted air con fitted on their twin point cars such as Japan models Price:
CHS2515- STUD FOR THERMOSTAT HOUSING WITHOUT SANDWICH PLATE (5/16") Probably the most changed stud on the mini? This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were replied. 5/16"unc and unf at nut end,this bolt is about 5cm long about 3.5cm from the bottom of the UNC thread Price:
Mini forward facing thermostat housing with gasket Price:
12A408- Thermostat housing with temp adaptor. This thermostat housing is fitted with an adaptor for the temp sensor, this allows either use of both mechanical and electric temp gauges, or in the early cars use of electric gauge to be fitted. Price:
CAM4044- 1000cc rear facing thermostat housing These where fitted to late model 76>81 mokes and minis, the outlet faces the firewall (not the front like on earlier cars) 1000cc Price:
AYG2388- 1275 rear facing thermostat housing These where fitted to late model 76>81 mokes and minis, the outlet faces the firewall (not the front like on earlier cars) Price:
PEG100030 - THERMOSTAT SANDWICH PLATE ELBOW TWIN POINTS ONLY MPI SANDWICH PLATE. NO HOLE FOR RAD BRACKET STUD. SAME CASTING AS ALL OTHERS BUT HAS LARGE DRILLED HOLE IN SIDE FOR TRANSMITTER Price:
AYG172- Mini heater take of plate gasket (side of head) This is the gasket that goes between the heater take off and the head on almost all mini heads. Price:
AYA121 Forget all the universal shape gaskets available -this is the original correct shape made out of thick gasket paper Price:
GTS102- Mini thermostat (74 degrees CELCIUS) Thermostat for Australian Conditions 74 degrees (suit warmer conditions) Price:
11G176- THERMOSTAT BLANKING SLEEVE Removal of the thermostat helps to reduce engine temperature; however a thermostat blanking sleeve should be fitted to maintain correct coolant circulation to the entire head. Price:
11G228- RAD TOP AND BOTTOM BRACKET ORIGINAL STEPPED BOLT FOR 2 PIECE COWLING Bolt that is stepped that fits on either the top of the radiator support bracket or the bottom, this bolt goes through the rubber grommet 11G227 and I would highly advise changing these at the same time. Price:
11G227/AYG2012 Radiator grommet This grommet is used on all top radiator to cylinder head brackets plus the bottom bracket on earlier two piece radiator cowlings Price:
GTR104/52710- Mini temp sensor This is a temp sensor that will do ALL models, the probe (part that goes into the head) is 9.45mm, there is another one (earlier) that is 8.60mm if you have the smaller one the hole in the head may need to be opened up to suit. Price:
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
.jpg){kind=small}
.jpg)
