Minisport
|
Minisport |
 
|
AUE810- Mini SU 1-/4" carby gasket set This is most gaskets you will need to seal up that leaking S.U. of yours. Price:
AUE811- Mini SU 1-/2" carby gasket set This is most gaskets you will need to seal up that leaking S.U. of yours. Price:
AUE34- Mini choke screw This is the choke screw that holds the inner choke cable to the choke mechanism, fits ALL SU carbies either twin or single Price:
12G297- INLET MANIFOLD LOCATING RING Locating rings originally made for 12G295 heads with twin carbs to lign up the inlet maniold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the head and usually the inlet manifold to take these spacers. Price:
FLOAT01- Mini fuel sender in tank float If your fuel gauge stops working then quite often it can be the fuel sender float. Once you have drained your tank remove your sender unit and have a look at the float, if it has fuel on the inside or is stained from the inside (usually red) it will never work and you need one of these. This float will fit any year mini. Price:
MINI LATE FUEL TANK SENDER UNIT As fitted to Leyland Mini’s, these are the late type fuel tank sender units, why would you even bother with getting your old one overhauled You get: Sender unit, Sender float, Sender sealing ring Price:
ARA1502- Mini fuel tank to fuel tank sender rubber seal Seal that goes between the fuel tank sender unit and the fuel tank, this stops fuel leaking into the boot. Price:
AAU8340- Van fuel tank sender unit Fuel level sending unit for mini wagon, van, and pickup with the flat tank under the rear of the car (near the subframe) Price:
GUG705711GM- PETROL TANK SENDER UNIT GASKET SCREW TYPE This round gasket has screw holes in to attach the early type (850) saloon petrol sender tank unit to the tank and was used by all vans and estates right up until the end of production. Price:
2A2069 - MINI TANK SEALING RING Sponge like cushioning seal for all minis between the tank neck and the body plus the minivan/estat/pickup petrol tank where it goes between and tank and the the floor/shroud, normally only used on Vans in Australia, but can be used on normal minis if you choose Price:
AEC2750 Mini twin carby return spring, suits either twin 1-1/4" or 1-1/2" Price:
1E5537- Mini carby return spring (1-1/4 or 1-1/2) This is the spring that pulls the throttle bracket back to idle, fits down to a bracket on the exhaust on 1-1/4" or to the bracket on 1-1/2" Price:
PPK1- Mini 1/4 braided line, 2.5" long, CARBY One of the nicest things about twin carbys on a cooper S is the small little fuel line that connects the fuel line to the carbys, these are sold single. Price:
PPK5- Mini 1/4 Braided fuel line, 12" long 12" long braided fuel line, 1/4" bore Price:
PPK6- Mini 1/4" fuel line 15" Long Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size Price:
|
 |
