Minisport
|
Minisport |
 
|
13H7286- Mini diff housing support rod bush (suits ROD change) This bush inserts into the rear of the diff housing, it only suits rod change cars from about 74on (it has two rods instead of the big alloy support gearchange) Price:
MSSK1- left hand lower engine stabiliser kit This kit is designed to greatly improve engine stability on all minis, mostly used on later rod change >73 model minis (clubman’s) easy to fit and will stop that engine from flopping around! Price:
22G418 Normal everyday engine mounts to suit any Manuel gearbox mini. Price:
21A1902ST- ENGINE MOUNTING WITH EASY FIT CAPTIVE THREADS MANUAL GEARBOX (SINGLE) Sold single, Engine Mount, This type has 2 nuts fitted to them making fitment easier when bolting to the sub frame when working under the car. Price:
21A1902GEN- ENGINE MOUNTING GENUINE MANUAL GEARBOX ONLY (SINGLE) You might be surprised to know how much these little mounts can impact your total car- handling, comfort and even controlling the chances of having the engine move so far as to significantly damage the carb or manifold, etc. Two required per car and the are only held in place by 5 simple bolts! Price:
GEX7081- EXHAUST MIDDLE MOUNTING This exhaust mounting bolts on to the front of the rear sub-frame and is the central or first of the rubber mountings. Price:
C-19G3257- EXHAUST MOUNTING COMPETITION ON FRONT OF REAR SUBFRAME The center exhaust hanger takes a lot of abuse during hard acceleration or if you're low enough to bottom out on bumps. This mount has a through metal bolt to keep it intact! Price:
GEX7248- EXHAUST HANGER CENTRE "S"AND RC40 This is the hanger on the front of the rear subframe for all Coopers and cars with an RC40 exhaust system. Price:
GEX7249- EXHAUST REAR BRACKET 1275GT & "S" PLUS RC40 this is the hanger on the rear of the rear subframe for all Coopers and cars with an RC40 exhaust system. Attaches to the cotton reel mountings. Price:
GEX7251- GEARCHANGE/EXHAUST MOUNT This mount fits on Price:
21A956 This is the mount at the very rear of the gear-change on remote gear-change (not rod or 850) Price:
RC40 Fitting Kit This kit has it all, all your mounts, clamps, and brackets for a complete exhaust fitment. Price:
Firewall secondary engine steady bar bracket Bracket that fits on your firewall bulkhead, this is connected to the engine steady on rod change/high performance motors. (Radiator side) and has holes for heater pipes to go through firewall. Price:
AYK2076- Stabilizer bracket cylinder head end suit 1000-1100cc (Thermostat) For use on all 1000cc to 1100cc engines, A must for engines fitted with rod change. For 1000/1100cc not 1275 these are available in our store. Price:
Stabilizer bracket cylinder head end suit 1275 (Thermostat) For use on all 1275 engines, A must for engines fitted with rod change. For 1275 only not 1000/1100cc these are available in our store. Price:
|
 |
