Minisport
|
Minisport |
 
|
BUMP STOP REAR HYDROLASTIC, LARGER RUBBER BUMP Hydro rubber bump stop fits on rear trailing arm (original type) Price:
21A1517- REBOUND BUFFER HYDROLASTIC,FLAT BUMP This is the flatter type rear rebound rubber on hydrolastic cars, uses exactly the same metal base plate as 21A1520 which is the larger cone type which is the bump stop rubber Price:
C-AJJ3313- PAIR OF COMPETITION BUMP STOPS (HYDRO) Rear progressive bump stop kit for hydrolastic cars. Mounting brackets and rubbers. Price:
21A1598- BUMP STOP HYDROLASTIC FRONT For Hydrolastic suspension cars, they were made with a 1/4" fixing hole but this needs elongating vertically to get the bump stop to sit properly on the upper arm which had different machine tolerances when manufactured Price:
C-AJJ4007- BUMP STOP KIT, FRONT Front progressive bump stop kit for hydrolastic cars. Mounting brackets and rubbers. Price:
FAM2764- BUMP STOP WITH SINGLE BOLT FIXING ON S/FRAME Original single UNF bolt bump stop as fitted to the sub-frame --make sure you fit UNF nuts (See our store for two bolt sub-frame bump stops) Price:
2A4332- BUMP STOP FRONT DRY SUSPENSION PRE 79 This is the dry suspension type bump stop with 2 threaded retaining bolts. Price:
Mini top arm bump stop AYA4033 This bump stop screw to the subframe and stops the top arm from hitting it and creating a BANG suits either Hydro or rubber cars as they both need these. Price:
21A1882 Rubber (PAIR-1 SIDE) As used on all leylands and most mini's from about 68 on, to be 100 percent sure if these will fit please inspect your lower control arms, if they taper in (where the bushes sit in the arm) then these are the ones you will need if not see N51491. Price:
21A1882MS- LOWER ARM BUSH EASIER FIT UPGRADE (PAIR) These are top hat type rubber bushes that fit all lower arms with a twin taper bush hole. All minis later than 1965. Fitted with metal bush insert. Price:
C-STR631 When the castor and camber angles are changed or the geometry of the car is set up you will require these bushes. They are good for cars with up to 3.5 degrees of castor angle. A must if using a C-AJJ3360 or 64 (1.5 neg arms or adjustable lower arms) Price:
C-STR632- LOWER ARM BUSH SET FOR MODIFIED GEOMETRY ROAD GRADE RUBBER These are specially made for use when geometry has been changed- such as fitting adjustable tie rods or lower arms or on any cars with corrected castor angles (set of 4 bushes) These metal sleeved bushes are specially angled to compensate for the newly formed angles of your car geometry when the car is set up properly. Price:
2A4294- Mini lower control arm bush, set of 4 (straight type) This is a lower control arm bush that suits the pre 66 cars, the lower control arm bush is straight (not tapered) like the later ones Price:
N51491 As used on all early mini's until about 66, to be 100 percent sure if these will fit please inspect your lower conrtol arms, if they are straight (where the bushes sit in the arm) then these are the ones you will need if not see N51145. Price:
2A5818- Mini rear subframe suppurt bushes These are the 8 rubbers that are fitted to support mountings for the rear subframe (all models) Price:
|
 |
.jpg)
